Ability to Power Up a PTZ Camera After Booting into 'Live Production' Mode

bwood

Member
If I have a PTZ camera already assigned to an input on a TriCaster and the camera is not connected to the network when I boot into 'Live Production' mode, the only way I can get that camera to be fully recognized (i.e. display PTZ tab) after plugging in the camera is to fully exit the TriCaster application and start it up again.

It would be nice if it automatically re-linked the PTZ cameras once they're available. This has confused my operators more than just a few times on my TC1s and TC2.
 
Top Bottom