Phones output after latest update

[julioac]

Hello:

I have the following setup:

The audio channels that I'm using are routed to Aux 1 and sent to a mixer. Then from the mixer I return to an audio input routed directly to the Master output of the VMC1.

Before the latest update, I could use the Phones output of the VMC1 to hear ONLY the audio from the Master output and if a channel was placed in SOLO mode, I could hear the soloed channel.

After the update, when I route the audio ONLY to Aux1 (the audio is NOT in the Master output) and the channel is activated, I hear it in the Phones output. It did not happen before.

Is there a way to change this?

Thank you.

[SBowie]

Sounds like a bug. If it persists in a new session, please open a detailed bug report.

https://forums.newtek.com/showthread...Reporting-Bugs