NDI|HX PTZ-UHD issues after processing VCAA104e Update today

[FrankPW]

Hi,

had VCAA104 running without issues since delivery. After installing VCA104e this morning both, Studio Monitor 4.5.3.0 (Runtime 10.Sep.20) and TC1 7-3-200918 show strange video signal, like using a wrong LUT. For now I tried Output Mode 4 and 5 for my initial further testing. Factory reset seemes to do not change the now installed VCAA104e back to previous FW (version installed @delivey of poduct). Any hints?

Thank you
Frank

[FrankPW]

HI again and fyi,

well, i figured out by now what might have happened on my end - VCA104e Update did change indeed the Picture effet (in camera Menu) from ´Off´ to ´neg´. All seems fine again after changing value back to ´Off´ for each camera preset.
Since no feedback so far in here I guess it was a personal problem since I was to much in well workung remote´ operaton mode with the camera still connected to a PoE switch only for power while processing the Update. I think this is not what to do in genearl for an Update of a device just gettingt power thru PoE, right?

Frank