Results 1 to 3 of 3

Thread: NC1 I/O and Dante audio

  1. #1
    Registered User
    Join Date
    Oct 2012
    Location
    Youngstown, OH
    Posts
    30

    NC1 I/O and Dante audio

    So, I just downloaded and installed Dante virtual sound card on my NC1 I/O (running 191104) it has been setup and is running on my Dante network. The problem is when I go into the supplemental audio devices nothing for Dante comes up. I am running the NC1 as 8 SDI outputs. Am I doing something wrong, I just trying to get the camera audio from my NDI cams into my audio board.
    Gear Used:
    TC-8000, TC-1
    3-Play 4800
    NC1 I/O, NC1 IN

  2. #2
    Is Dante running in WDM or ASIO mode? I've have to check, but it might have to be WDM mode.

    One other possibility, for ASIO mode, I've found that sometimes you need to delay the start of some of our application, as Dante take a little time to initialize in ASIO mode and isn't ready by the time the application starts.
    Kane Peterson
    Solutions Architect
    NewTek, Inc.

  3. #3
    Registered User
    Join Date
    Oct 2012
    Location
    Youngstown, OH
    Posts
    30
    So, I was able to get it to show up with it set to WDM mode, thanks.
    Gear Used:
    TC-8000, TC-1
    3-Play 4800
    NC1 I/O, NC1 IN

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •