Results 1 to 4 of 4

Thread: lwsn.exe -2

  1. #1

    lwsn.exe -2

    I am searching for a controller which supports lwsn -2 and does not use lwsn -3.
    To explain .. I need a controller which loads the scene once, does the setup once ( subdivision, etc .. ) and then sends the command to render frame x, then frame y, and so on ..
    Most of the controllers I found just use lwsn -3 which is more or less batch rendering of frames which is unusable for our purposes.
    We have quite high scene setup times .. if each frame loads the scene and does the setup i would guess just 30% of the time is spent on rendering ...
    martin dulovits
    technical director

    www.woogieworks.com

  2. #2
    LightNet (Classic) ran on LWSN -2 though it's not being actively developed.

    http://www.joejustice.org/


    LightNet: Cloud is Joe's new project, though I'm not sure how it works.


    For the record, LightNet, once upon a time, was the mainstay of the company I worked for. While it had quirks, and pumped through our renders like a good workhorse. But I'm not sure how well it will grok the newer LW versions.
    "The hardness of God is kinder than the softness of men, and His compulsion is our liberation." - C.S. Lewis


  3. #3
    Here in the same subforum I just saw this: http://www.lightspeedrender.com/
    "The hardness of God is kinder than the softness of men, and His compulsion is our liberation." - C.S. Lewis


  4. #4
    I'm using BNR4.58 and itīs Lwsn-2 based.
    It have lwsn-3 option too.

    Not sure about BNR5.
    I think its lwsn-2 because Paul the dev knows the benefit of not reloading the scene Each time.
    But i hadnt update.

    Regards,

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •