PDA

View Full Version : flow animation help



toshgaal
05-14-2009, 01:38 PM
Hey All,

I have an animation to do and I am not sure which would be the best way to do it, and I thought someone out there may have a suggestion. Attached is an image that shows what I am trying to accomplish. This is plastic flowing in a manifold of an extrusion die. it starts in as a square entrance and then splits around a radius corner going into two different directions. I am not sure if I should use morph targets or maybe use an emitter. Could someone give me some direction before I put too much time into something that may not work? Any help would be appreciated.

Thanks,

toshgaal