PDA

View Full Version : Need Help



youngb305
03-17-2009, 03:01 PM
Can anybody instruct me on how to create a "Zune"

flakester
03-17-2009, 04:53 PM
Sure.

Grab yourself a Wolfson chip, and some bits of plastic; make sure a few of them are button shaped. Then grill them for a few minutes and press it all together firmly with a pair of sturdy gloves. Bingo! Job done!

Dang, forgot the headphone jack... !

Sorry.

Seriously, grab yourself some blueprints, or a side, top and front (also underside, if you want to go that far) photo if you have access to a Zune, and place them into Modeler's viewports. Then set about creating geometry to match those shots.

You may want to do some reading up on subpatch modelling (or modeling, depending on where you come from), a search within the forums should yield some decent results, or google instead; a very good place to start is here (http://www.lightwiki.com/Fundamentals_of_Subpatch_Modeling).

Hope that helps.

--
flakester.

:edit: Actually, I'm not sure if the Zune uses a Wolfson chip at all....

youngb305
03-18-2009, 08:44 PM
thanks.....i'll try it