View Full Version : VT4.6 hangs at synching time

02-24-2009, 08:03 AM
Newtek replaced my card due to an hardware failure on the analog video input channel, and now I installed back the new board in the workstation.


Now, when I start VT application or when I lanch 'auto configure' both applications hangs trying to synch with (PAL) external signal ....

Any one had same type of problems?

I already tryed full unistall and reinstall of toaster package with no success :help:

02-25-2009, 06:11 AM
I moved the VT-board (with contact cleared with a rubber eraser) on the 1st pci slot of my workstation and now VT runs the auto-configure procedure, but ..... VT software still doesn't start.

... I tracked the beaviour of VT application during start-up .... and I noticed that Winrtme will not be started .....

Any hint?

Paul Lara
02-26-2009, 12:20 PM
Tech support should help you with this. The driver won't start if it cannot properly communicate with the VT board.

03-20-2009, 10:38 AM
The board was broken :(

.... Newtek support exchanged the board with a new one and now ....

He goes :D

PS: I connected the Fujitsu workstation to an UPS to ensure the PC with a clear-perfect electrical power :thumbsup:

thanks Newtek another time :D