View Full Version : Light Bleed

Richard Hebert
02-08-2009, 06:36 PM
Hi Everyone,

Was trying out secondary bounce feature in GI and I really like the effects. I encountered a problem with light bleeding through the model and wondered if anyone else has had an issue with the feature or with the lights in general. The problem only seems to arise with Secondary Bounce feature active but not sure if that's the cause. Any thoughts?

02-08-2009, 06:58 PM
This may give you some ideas as to configure your GI and bounce settings. Exception has documented some really excellent information here.


Richard Hebert
02-08-2009, 10:04 PM
Thanks Hopper, It's been a while since I've read this and the info. on SBRs will help with this.


02-08-2009, 11:02 PM
No problem. I don't always know the answer ... well, ok .. I RARELY know the answer, but I usually remember where to go look. :D