PDA

View Full Version : it would be nice if 'Connect' would deselect the points after connecting



zardoz
12-05-2008, 12:02 PM
big title to say it all...

most of the time I'm using 'Connect' to cut ngons into quads or tris but it's annoying to deselect the points after using it.
It would be nice to:
1st select points
2nd use connect
3rd select new points (the way it works now we have to deselect points)
4th use connect again
...etc

it's something simple but it would improve the workflow a lot

PS: maybe we could have some preferences file for tools and connect could have this option on or off 'leave points selected after using'.

tx

Sekhar
12-05-2008, 12:24 PM
Check out Edit->Edit Modeler Tools and see if that helps.

zardoz
12-06-2008, 06:33 PM
well, I checked it, and that isn't an option in Modeler Tools...so, what I'm asking is still valid.

Hopper
12-06-2008, 11:21 PM
I'll second that request.

When Bridge just can't figure it out, it sure is a pain to select->connect->deselect over and over and over. Even when deselect is a hot-key assigned to a mouse button, it's tedious.

Hmmm .. well, as a short term you can always make an LScript and replace it (not the command itself). Create an LScript that executes the connect command, then deselects. Call it "Connect+". :)