PDA

View Full Version : VT 5.2 Upgrade Problem



VOLiCrew
10-13-2008, 12:34 PM
We have just upgraded to 5.2. The one problem I have been noticing is that when I start up the VT software it loads and a half second later it exits out and askes if I want to send an error report to microsoft. Only after I shut down the computer and restart it does it load up properly. This has happend the 2 out of the 5 times I have loaded the software since the upgrade.

Was wondering if anyone else was experiencing this? If so is there a fix?

animlab
10-14-2008, 11:09 PM
I will suggest you call NewTek tech support.
One of my customers have similiar problem when his VT[4] upgrade to VT[5] and I send the VT board back. They replaced a small chip and everything go fine.