PDA

View Full Version : Can't Open Project



SteelPicR
08-10-2008, 01:31 PM
I’m 5 days into editing a 3 camera shoot totaling one hour ten minutes. I’m down to the last 4 minutes of the project. I shut down with everything working fine. Today when I tried to open my project I get a Microsoft error crash. I have narrowed the problem down to one of the sub folders in my master project clips folder. I have the folders set up as Project Name>Cam 1>Cam 2>Cam 3 on the video drive. I found by changing the name of Cam 2 folder that I could then open my project…of course, all of Cam 2 clips are gone and placeholders are left instead. I then started removing clips out of Cam 2 folder from the back of the project towards the front. I then found that by removing the last 10 minutes of clips from Cam 2 that the project would again open.

I have cleaned all temp and missing files and deleted all Newtek info files. The event viewer log gives this event:
Failing application vt[5] exe. Version 0.0.0.0. failing module msvcr80.dll. version 8.0.50727.762. fault address 0x00015178.

Any help please…this is due to go out tomorrow. Thanks guys.