View Full Version : Bevel troubles

07-09-2008, 12:37 PM
in LW 7.5

i make a 1 polygon 1 sided square and apply a inset bevel so that the bevel moves into the square.

however, if i flip the square around to see the back side the surface has extended onto the back of the square only as far as the bevel went. (so i now have a 2 sided square but only as far as the bevel went)

i dont think i have any settings wrong. I tried to reload the plugin for the bevel tool, but was unable to see that one in the plugins folder.


07-09-2008, 07:20 PM
ok, i figured out my problem

thank you for looking :)