PDA

View Full Version : Controlling UV mapping in layout



pdp editor
07-04-2008, 12:48 PM
I have a box with an image UV projected onto it and would like to move the points to move the image in Layout. I searched the forums and have learned that this is done with morphs, thats great, not much information found on the step by step process for this however. A tut I was following is restricted to Modeler- It does not go on to layout and thats odd for a tut about Endomorphs- a tool that requires both Modeler and layout. I setup the object in Modeler and animate it in Layout. these two go hand in hand and should not be disjointed in any tut. If you could point me to an instructional link that would be great.

SplineGod
07-04-2008, 08:24 PM
You could use a bone on each vertex of your box and move it that way. You could also mdscan the box using clothfx then use the editfx tool to move the points around. Theres also a free plugin called minimo that will allow you to animate points in layout. Its located here: http://www.lwplugindb.com/Plugin.aspx?id=55278d60