PDA

View Full Version : Any Involutes lurking around here?



rakker16mm
01-07-2008, 12:46 AM
It would be very handy to know how to generate a true involute curve in modeler. They are especially handy for making accurate gear shapes, and besides that they are really just a very beautiful curve. They are useful for animation as well.

Here is a nice example of one (http://www.abbeyclock.com/gearing4.html#CHART).

The Involute Curve (http://www.cadquest.com/books/pdf/gears.pdf)

I thought I might be able to generate them using "Create>Curves>Plot 1D" but the interface and I are not meshing properly ( sorry ). So far all the documentation I can find on this tool are these to paragraphs...


The Plot 1D Tool
The Plot1D tool, which is located in Create > Curves: Plot1D, generates either a curve consisting of two-point Polygons or a spline curve. The curve is generated along the X axis, and its height is in the Z axis. Get your math cap on for this tool.

The height is determined by the value of the expression in the Equation field at each x. In the fields Min, Max, and Division, enter the x value for the start of the curve, the x value for the end of the curve, and the number of divisions of the curve.

meshpig
01-07-2008, 02:04 AM
Try posting in the Lscript section, there's probably something out there.

I agree, it's a nice curve.

m

rakker16mm
01-07-2008, 03:18 AM
That sounds like a good suggestion? Where can I find the Lscript section?

rakker16mm
01-07-2008, 03:25 AM
Ah never mind I found it :thumbsup:

Thanks again.

rakker16mm
01-07-2008, 02:12 PM
Ah never mind I found it :thumbsup:

Thanks again.

The Lscript section that is. I'm still looking for the way to generate an involute curve.