PDA

View Full Version : issue on changing from PAL to NTSC and vice versa



sunshung
07-23-2007, 08:27 PM
Hi everyone,

I am using VT4.6 with SDI-SX. Everytime when I change the video mode (PAL to NTSC) in prefrence VT4 will just crash with a WinXP pop up error message asking me to close the application. When I run autoconfigure, its will just stop at NTSC and the same Windows error message shown.

I found out that without installing the SDI-SX driver this problem won't occur. I can change from PAL to NTSC and NTSC to PAL happily. And autoconfigure will run smoothly.

Here is my system configuration.
- Intel S5000VXNSAS motherboard
- Intel Dual core Xeon 3.0Ghz
- 2GB ECC RAM
- Nvidia 7300GT 256MB DDR3

Thanks in advance. :-)