View Full Version : Hub probs

06-22-2007, 07:47 AM
in 9.2 UI cant swtch from modeler to layout using the upper right tab that would normally open the other program and the current file that I was working on, I get an error massage stating layout or modeler not connected to hub, anyone else have this problem? can it be fixed or what. not that its a major prob it just helps me streamline my work especially if I have to go back to modeler to do a slight geometry change.

06-22-2007, 01:03 PM
I found that making a Hub shortcut can help.

It needs to include the -c option to point to your config folder, if you have one.

Once the Hub has launched, you can launch Layout or Modeler from it and they came up almost instantaneously.

There's a bit about this, including pre-made shortcuts on my site http://www.simon-coombs.com/setup/

Let me know if that does it for you as this whole Hub thing does seem to vary from one machine to another.