View Full Version : Help with Adjusting Back-ground Templates..

03-21-2007, 11:10 AM
I need help Adjusting my back-ground templets in modeler. I think what I need is PS help, since i cant cut up the blue prints to get them to line up in modeler. Any 1 help? or can point me in the direction of some PS tuts to help me learn how to adjust blue-prints for modeler?

03-21-2007, 04:36 PM
Something to could try is place each profile on it own layer, power the transparency some to see the layer below, then you can do one of the following, add white space around the image, crop the image, or rescale the image. Then save out each layer to it own file.
Hope this helps,