PDA

View Full Version : Unusual layer visibility after loading



dwnylen
08-23-2006, 05:00 PM
I've created a model with multiple layers (in the Mac OSX version). When I restart modeler and reopen the model, only some layers are active and not those that were active when the model was saved.

This is mildly annoying in Modeler, but causes more problems in Layout which seems to only load the visible layers (which makes sense).

From what I can tell, it's always the last three layers which are active after a restart/reload.

I have the problem with the red dongles, so I'm operating in discovery mode, but I doubt that has anything to do with this.

Any suggestions?

dwnylen
08-23-2006, 05:50 PM
OK, I've figured it out. I must have accidently disabled certain layers inside the layer panel, probably when i renamed them.

I unconciously assumed that 'editable' implied 'visible' as it does in Photoshop.