View Full Version : Bandsaw/symmetry issue

08-12-2006, 04:03 PM
bandsawed a symmetrical object - once on one side of the Y plane and then on the opposite side of the Y plane (identical polygons on both sides). When bandsaw was done (bandsaw set on 50% in both operations) symmetry was lost. Points on splits off by a bit. Used to do this ALL the time in 8.5. Am I missing something? Any one else notice this? Is there a: "I really do want to keep symmetry when I bandsaw my model" button?

actually the points are perfectly symmetrical on the X axis but they're not on the Y or the Z.