PDA

View Full Version : Fillet Tool needed!



jthompson3d
07-12-2006, 12:07 PM
Is there any fillet tool or plugins anyone know of, the only one i could find was JettoFillet but it doesn't work in Lightwave 9. I need to grab a point and round off the edge, for those who know JettoFillet.


:help:

colkai
07-12-2006, 12:43 PM
ume_polyfan does the same, but only on one point at a time, alas it is not interactive, but it's pretty intuitive..
Of course, there is LWCAD2, but depends how far your wallet stretches.

Celshader
07-12-2006, 12:47 PM
For what it's worth, R_Welder costs $10 (http://www.pictrix.jp/lw/index5.html) and does this:
http://www.pictrix.jp/lw/Rweld/index.html

jthompson3d
07-12-2006, 01:19 PM
thanks guys....I really want the interactions that JettoFillet has, the interactivity helps a lot so everyone at my work doesn't have to try some numbers undo try it again undo until they get what they want the interactivity save a lot of time.

I have looked at R_Welder but doesn't look like what I need. As for LWCAD2 i havn't seen anything like this in there, can u point it out to me.

Here’s what I am doing, I will have a flat poly that i create with pen tool and then go back and fillet some of the corners to make better res, that what I am using it for. I work for an architectural firm that we use this for site for on curbs and other things.
:question:

Any other ideas.

kruemel_1
07-12-2006, 02:02 PM
LWCAD2 has for example the DArc tool:
http://www.wtools3d.com/index.php?p=3&content=online_help
Real-Time Drilling
Other tools as the Engraver (see the tutorial section part4) are also great savers for Architectural work.