PDA

View Full Version : Installing DVD Workshop SE



kleima
06-29-2006, 03:23 PM
You know, when I first got VT[4] I never installed DVD WSE (either that or I uninstalled it later b/c I didn't like it - I don't remember which). Anyway, now I would like to run a project through it, but I can't figure out where it is, or how to install!? It is not listed in the program list at the begining of the VT install setup.

Pete Draves
06-29-2006, 03:42 PM
it is found on your 2nd instalation disc.
just run the install program.
you will need the serial number in the inside front cover ov your manual binder
Pete

kleima
06-29-2006, 04:23 PM
Ok, I didn't see it there either, but I'll look again. Does it only show up after I start the installation?

Pete Draves
06-29-2006, 05:10 PM
if you open the disc it is in a folder named "dvdws"
open the folder and double click setup.exe

if you have only one disc (lw7.5), then it is on disc 1
then cancell out of the toaster install and open the disc.
follow instructions above.
Pete

kleima
06-29-2006, 07:55 PM
Oh, thanks, now I found it!

Pete Draves
06-29-2006, 08:11 PM
good luck
the program works pretty good

most people are useing tmpenc encoder for quality issues

can be found at pegasys.com

Pete

wvp
06-30-2006, 07:17 AM
And you can use DVDWS to encode audio into AC3, even if you want to use another program for the authoring.