View Full Version : Surface baker and front projection: problems

05-28-2003, 10:48 PM
I've used Surface Baker with no problems in the past, but today I was trying to use it to bake a front projection mapped image onto a wall (see first image) so i could animate the wall (long story). it all seemed to work, and the UV map looked correct at first glance (second image), but when I loaded it back in and wrapped it onto my model.....(look at the third image). I didn't have my photograph with me today when I made these tests, so I used a generic newtek image I had on hand, but I've tried it with different resolutions and different images to no avail. Anyone have any suggestions?

05-28-2003, 10:49 PM
ignore the little streak in the first image. my computer sometimes has a problem sending files over the internet and corrupts them. just assume it looks like it's supposed to look on top, and wrong on bottom