View Full Version : Rendering Problem

04-29-2006, 12:31 PM
I'm new to LW (2 months) and this is my first attempt at modeling and rendering my own object from scratch (everything else I've done has been through the guidance of tutorials. So I'm not sure if this is being caused by my model or if I have some of the render settings set incorrectly. On the attached file you'll see there's a line that's going around my subpatched object that shouldn't be there. If anyone can tell what's causing this I would appreciate it.

04-29-2006, 12:34 PM
it looks like a 2 point polygon chain. I modeler open the statistic panel (w) in Polygon Selection Mode and select Polygons with 2 points (with the little + in the statistics) and delete them.

04-29-2006, 12:40 PM
That was it. Thanks alot. I didn't even think that it might be an object on it's own. I was thinking it had to be an artifact because I couldn't see it until I rendered. Thanks Again.

04-30-2006, 04:37 AM
Whats with the weird reflection in your coffee? Seems somthing is wrong there too...