PDA

View Full Version : Need advice(help) on poly flow



monfoodoo
03-17-2006, 11:13 PM
I keep getting myself into this situation when i'm modeling. what i figured on this valve cover,was to model it with the flat ends and then try to pull that slope in the back.since the two covers are just rotated to each side of the head but the slope is in the rear.How do i avoid these tris,i,m stumped.scott

toby
03-18-2006, 01:30 AM
This is one of the reasons not to model in faces when you're going to end up subpatching it. Start with subpatches - but to fix this one you could go back and convert it to subpatches before you pull down the slope at the end.

monfoodoo
03-18-2006, 11:00 PM
I think I'm in for some trouble