PDA

View Full Version : is this Tutorial any good



Oxide
05-01-2003, 12:42 PM
i found this tutorial and i was wondering is this any good or is there ny over better ones out on the net.

click the link for the Tutorial
Subdivision Modeling of a Human (http://www.3dlinks.com/tutorials/softimage/subdivision_human_1.cfm)

marvin
05-01-2003, 03:43 PM
My opinion is it's NOT that great because it skips certain steps. It says “adjust some points” where if you were to adjust the points, it could take about an hour or two of adjusting to get to the place they got to. Use the knife tool from setp one would not get you step two. You would also have to move a point, or more likely, delete a point and create two new faces, which it doesn't mention. If you are moderate at least and can figure this out, then it's cool. For a newbie, with very little experience it would just end up being confusing.

My 2 cents, which seemd like 4 by the length of what I wrote. Sorry.

marvin