View Full Version : Paper modeling help

08-19-2005, 11:37 AM
Hi All,

What's the best way to make a map map fold in half? I've tried endomorphs but I can never manage to get the map to fold properly. I've heard bones are the way to go but I haven't had a lot of success with this. Is there a good tutorial around?
Also still on paper, anyone know the best way to simulate a page of a magazine being turned? Again any know tutorials would be a massive help.

Thanks in advance,


08-19-2005, 01:35 PM
There is a tutorial on unrolling a parchement on this site in the tutorials section. Products/Lightwave/learining/Written Tutorials. That might help give you some ideas.

08-19-2005, 06:17 PM
If I remember right over on spinquad some one donated a page turning rig.
Ok i found it the link is http://www.spinquad.com/forums/showthread.php?t=7548

08-19-2005, 06:25 PM
Also isn't there that newspaper folding tut from the guy at DAVE school on this site too. You know, the one from the Spoon Man movie. I think It's right there in the same tutes section here.

08-19-2005, 06:30 PM
Yep, I recall that tutorial. I found it the link is http://www.newtek.com/products/lightwave/tutorials/animation/newspaper/index.html