View Full Version : unrolling an object

05-24-2005, 03:23 PM
I need help! I have to take a "rubber" disc 30 feet in diameter and roll it up into a cylinder and then unroll it. How would I go about doing this? I know I can do it with bones, but is there something in LW8 that would make it easier or quicker? Thanks for any help.

05-24-2005, 04:31 PM
spline control in layout would probably be easy and quick.

05-24-2005, 09:38 PM
If you are not going to use bones, check out the weightmap folloff tutorial


there's a great one on using it with rotate.

Using this you could have several endomorphs to fake a nonlinear morph at varios stages of the curve.

Not sure how you are going to do it but this may help.