View Full Version : Saslite_weight_maps

red fox
04-15-2005, 08:18 AM
Is it possibel to tell saslite to where to grow using a wieght map and not a surface name. If so how would i set one up?

Red :confused:

red fox
04-15-2005, 08:21 AM
I should really us spell checker..... :D

04-15-2005, 08:31 AM
You can't use anything other than surfaces in saslite.

red fox
04-15-2005, 08:54 AM
How would you then apply a fall-off to thin out a fur texture? For example face stubble dose not finish with a sharp edge to it gradually falls away around the neck area.

04-15-2005, 09:19 AM
Methinks you may need the full Sasquatch animal for that bit-o-trickery.

04-15-2005, 11:32 AM
Yup, weight maps and UV maps etc are only available in Sasquatch full...

04-15-2005, 11:38 AM
And Golly Gee Worth It!

04-15-2005, 12:10 PM
You could try setting your surface-then make a new surface 1 poly ring out from the other surface. Then use the same saslite settings but changing the clumping/coarseness. This may give spread into your first sas surface and spread into your non sas surface.