View Full Version : amoeba-oid shapes how best to

04-11-2005, 12:47 AM
What would be the easiest way to draw flat amoeba-oid shapes for such things as this kids pool tube shoot?

Pen tool works but does not make nice curves at least not without click-in a lot. Spline draw gives me a nice curve but no poly. What ya think. How should I go about this.

Thanks for your help.


04-11-2005, 01:35 AM
Here is your water objects. When you use the spline tool, to get a poly you need to freeze the spline. The river, I traced the outline then did a drill>tunnel to remove the center island. I did the same thing to the left pond. I named the land objects as subtraction objects and move them to far away layers, If you need them for texturing the land, they are there for you.

04-11-2005, 11:28 AM
Silkrooster thanks for the effort,

What I would really like to know is is there any easier way to do this.

Maybe I should post in the feature request section.

What I think would be very helpful would be a tool to draw polys much like the pen tool, but as a spline or curve, with all the features of Magic Bevel.

04-11-2005, 12:03 PM
Ok update here,

Turns out that LWCAD does a respectable job with this. You can make a spline then, choose curve to ploy - and there you go a amoeba shaped poly. Thanks Viktor!