PDA

View Full Version : LW display problem - Help!



Milendrin
12-29-2004, 07:47 PM
I'm using Lightwave 3D v7.0 and have encountered some kind of technical hitch (I think). The interface panels that come up when you select Surface editor or Clone normally have a grey background in the rectangular boxes into which values are typed (e.g- X+ offset). For no apparent reason, both Modeller and 'Layout' are showing a white background which has rendered the text invisble.

Any advice would be greatly appreciated. Thanks.

Milendrin.

JamesCurtis
12-29-2004, 08:57 PM
Most likely you need to either update your vid card drivers or double check to see if you have inadvertently installed a language pack [notably Japenese]. For some reason this causes a problem with text display as noted on other threads on the discusion board.

Hope this helps.

mrunion
12-30-2004, 07:26 AM
It's the language pack. A quick search on this forum will prove that to be the case. (Of course, you *may* have discovered some new anomoly, but statistically it's the language pack.) Also, 7.5c fixes this I believe. It should be a free upgrade for you I think.

Milendrin
12-30-2004, 04:05 PM
It was the language pack. Much obliged.

Milendrin.