PDA

View Full Version : Need help with Rounder badly!!!



no fate
11-25-2004, 03:07 PM
Hello all. I am trying to rouind off the inside edges of the opening in the pics. The problem is when I do, one side is messed up while the rest work exactly like it should. All points are properly merged, welded, etc. I can't for the life of me figure out why this is happening. I am getting VERY frustrated here!!! Any help would be great!!!

Matt
11-25-2004, 03:31 PM
Rounder has trouble with some geometric conditions, and you've found one of them! There's no way around it! Sometimes you have to do some cleaning up after.

If Rounder supported variable filleting you might be able to run the fillet out to nothing.

The alternative is to use sub-division modelling which will give better results in this case.

no fate
11-25-2004, 03:34 PM
I was afraid of that, lol. Thanks for the help though my friend.