View Full Version : Rounder Safety Valve error

11-20-2004, 10:05 PM
Iím getting an error when I use rounder. Safety Valve hit (E882). I read some other posts about rounder errors that suggest there might be un-merged points but that doesnít seem to be the case for me. Any idea what might cause this error?

11-21-2004, 07:58 PM
Ok I'm still not possitive what caused the problem, but I'm not haveing it anymore. I have another question though, why causes lathe to sometimes creat an interior set of polygons?

11-21-2004, 08:49 PM
I noticed this with the lathe tool as well. I beleive it it cause by creating the profile in the wrong direction. I have not really tested this theory out, but if you create an object lathe it and it is inside out press undo and flip the profile then lathe, I think you will find the object now has the normals to the outside.
Sorry I couldn't help on your other problem, I have never seen that error before. Perhaps reloading the plug in will cure it.

11-22-2004, 07:59 PM
thanks for the help that fixed my problem.