View Full Version : Not enough points selected????

09-01-2004, 08:19 PM
This is probably a simple problem for someone. I have a model in which I erased a 4point polygon, and now I'm simply tring to put it back. I pick the 4 points and hit "p" to make the polygon, like I have done many time before, but this time a little window pops up say "Not enough points selected"
I can't figure out why it's telling me this......

09-02-2004, 04:03 PM
I never seen this problem before, can you post up the problem part of your model by any chance (not the whole model, just the problem portion)?

09-02-2004, 10:00 PM
First I would look in the lower left hand corner of modeler and see how many points are selected. I suppose it is possible when you selected the fourth point that the third became unselected. Looking at it in one of the oragonal views it would look selected.

10-16-2004, 11:32 AM
This is because one or more of the selected points are in a different layer.