PDA

View Full Version : Newbee question



Blasterface
08-21-2004, 09:48 PM
For some reason when I select a polygon on say a box LW used to select the opposite side as well.
It now only selects one side. I've tryed symetry with no result.
Is there a setting that I can use to cause LW to select both sides
as it did when I first started using it?
Thanks

druitre
08-22-2004, 11:07 AM
It depends on what mode your viewport is in - wireframe, shaded/texturedshaded etc. As long as you're in wireframe, LW sees right through your object (just as you do), in shaded modes it only sees whatever you see - the front of your object and a bit of the sides. (for the same reason, you can select a poly in wireframe mode only by clicking the edge (the wire) of the poly, while in a shaded mode you can click the 'inside' of the poly)

Blasterface
08-22-2004, 03:04 PM
Thanks so much that was it.
Wireframe did the trick !