PDA

View Full Version : Rail Extrude question.



dreamline
08-09-2004, 05:17 AM
Hi all,
I've read around the forum and haven't found my problem solver... :(

Im doing a rail extrude of a ball/disc. Sofar so good, everything looks nice, however on some corners because the (corners/points) of the curve are very close to each other the extruded discs overlap each other..

Is there a way to get those overlapping corners to merge into one another.. Or does that have to be a manual process?

Thanks for any help... :)

Dodgy
08-09-2004, 08:03 AM
Unless you think pressing 'm' to merge them is an automatic process, then this is the a way to go..

dreamline
08-09-2004, 10:03 PM
Thanks dodgy, but i think i found the solution... Just a little manual editing is needed together with a boolean like intersect.. :)