PDA

View Full Version : Print to tape/ rendering?



battcom
05-27-2004, 12:26 PM
I insert commercial breaks into my shows with Print to tape on T3 build 4909. Basically, 5 flattened 30-second spots. No rendering required, right? But when it prints to tape, maybe the 2nd or 3rd clip stutters, so I have to put a forcer render under it, which is crazy since these are flattened opaque rtv clips. Anyone else getting render problems on starightforward print-to-tape matters? The timeline plays fine when not in print-to-tape mode.

Thanks
Jeff

John Perkins
05-28-2004, 07:44 AM
Maybe the file is fragmented? Try doing a defrag.

If the drive was getting fragmented when you rendered that final RTV it is posssible that it got scattered all over the drive.

Other than that, I'm not sure.