PDA

View Full Version : saving files to open in photoshop



triska
05-19-2004, 04:46 PM
I'm new to using the 3d lightwave program so......... When you save the image which is made in the lightwave program,how do you save it so you could open it up in photoshop? Is this possible or not at all?

robewil
05-19-2004, 04:57 PM
You must be new, you posted in the wrong forum.:)

If you are talking about a single rendering, just make sure the Image Viewer is on (in the Rendering Control Panel). After your image is rendered, you will see it in the Image Viewer. In the upper left corner, you should see a pull down menu to allow you to save it in all sorts of formats, most of them are supported by Photoshop.

triska
05-20-2004, 04:22 AM
Akk...SOrry about that. I went through the troubleshooting area and then clicked on something which took me here. But yes..THanks...

I will keep reading-:D