PDA

View Full Version : Making a Logo Appear



bruiserx
04-26-2004, 11:45 AM
I have a render question.

I am making a logo animation and want to do an effect where the logo is on the screen. I would like the large gold ring to pass over the logo (and be used to "key out" to a news set). What I can't figure out is since the ring is somewhat thin, and doesn't cover the logo entirely at any point, how do I make the logo disappear from right to left over about 15 frames, and still allowing the back side of the ring to be seen on the parts of the logo that is gone (even though it is technically behind the logo at this point)?

Does this make sense?

Thanks

WizCraker
04-26-2004, 12:39 PM
Compositing. Render out the two elements then bring them in to a compositing program and do your magic there. You will have greater control over the final effect without rerendering over and over and over.