PDA

View Full Version : No Component or Y/C out



cvsun
04-11-2004, 10:08 AM
Wondering if hardware or software problem. Have not needed to output video lately so just discovered this problem. Updated to 3 last november. downloaded lattest patch last week. went to send bars to tape yesterday. nothing. checked pins, cables, connections, reseated card in mach., confirmed that deck is sending video to monitor. there is composite video out. if i select video in on the deck and attach BNC cable from comp out to video in, it works. checked pref. switched back and forth from Y/c to component. still nothing. Any suggestion?
Thank you
CV