PDA

View Full Version : Using Surface Baker with Simbiont LW7 ?



Emmanuel
02-10-2004, 01:27 PM
Hi there !

Does someone know of a way to get the Simbiont Shader working with Surface Baker ?
I read in the guide to Simbiont that the position in the shader stack is important, I tried two combinations (below/above Baker), didn't work.
There is something baked out, its not usable though...


Thanks !

Macet01
02-10-2004, 01:58 PM
I don't personally know. I do know that their technical support is top notch. Give them a call and they will tell you what you need to know. If they don't know the answer right off they will call you back after doing some research.

mattbolton
02-10-2004, 02:34 PM
I have used DarkTree Shaders with Baker several time with no glitches. What exactly is the error? Some prerequisites:
Surfaces and U/V maps should be "paired", in other words do not have a surface on more than one UV map. UV maps are required; Atlas projection, in this case, is best. I can't think of anything else, it's been a while since I last did this, but I'll post again if I think of anything else.

hunter
02-10-2004, 04:33 PM
I had a problem once and there is a switch somewhere in the simbiont optoins panel turn off darktree shading.

Bytehawk
02-10-2004, 05:35 PM
If you own Darktree you can bake the textures in Darktree instead of LW.

Baking simbiont procedurals in LW hasn't ever posed a problem for me though.

Emmanuel
02-12-2004, 11:44 AM
Hi,


here two shots to illustrate what happens:

mattbolton
02-12-2004, 02:21 PM
Let's see a screenshot of the UV map.

Emmanuel
02-13-2004, 02:56 AM
ATLAS Uv map...I also played with the camera near/far numerics with no success...

Emmanuel
02-13-2004, 02:57 AM
Oops...

hunter
02-13-2004, 06:32 PM
Longshot but have you tried unwelding it and baking?

Emmanuel
02-14-2004, 04:36 AM
Nope, will try it, will also try to see if it looks different when I triple it...