View Full Version : Snowman's Nose is wrong from front...

01-31-2004, 11:30 AM
Hi all, I was attempting to create a snowman in LW (obviously :) ), and everything was going fine until I got to the nose part. Now I am stumped. I created a cone, and extruded it, then resized it until it looked like a carrot, to use for his nose. But once I positioned it, if you look at it from any angle other than the front, you can see the carrot pretty good. However, if you look at it straight on, it's invisible! I can't figure out how this happened...anybody know?

Thanks again to all of you :)


01-31-2004, 12:26 PM
Sounds like you may have the polys pointing the wrong way. Select the polys of the cone and flip them (f key) and see if that fixes it.

01-31-2004, 02:08 PM
That did it, it looks GREAT now...

Thanks a bunch :)