View Full Version : Layout resetting LWM geometry -- wth?

08-27-2016, 03:15 PM
Experimenting w/mirrors, I moved the Edges over in this mesh to make the BLACK area bigger.

But Layout keeps reverting to the old mesh, and even forces MODELER to lose the changes I've made, even AFTER SAVING THE CHANGES. (!!!)

I've never seen this behavior before, obviously this is undesirable. Any idea what might be going wrong?

If I use F12 to switch, any changes INCLUDING SAVED CHANGES are undone. If I use ALT+TAB to switch, it's fine.