PDA

View Full Version : Just starting LScripting...



whattawa
03-06-2003, 04:12 PM
Hi, just started LScripting and I was trying to get it to read morph data from a point and then transfer that data to another point. Once I get the data I'm pretty sure I will be able to transfer it. I have been searching but I can't seem to find if I can even get all that info from a point.

This is in Modeler, by the way.

faulknermano
03-06-2003, 09:01 PM
here's a sample that might set you on the right direction:



selmode(USER);
editbegin();
src = points[1]; // source point
tgt = points[2]; // target point

vmap = VMAP(VMMORPH); // vmap constructor

while(vmap && vmap.type == VMMORPH) // cycle through vmaps
{
if(vmap.isMapped(src)) // checks if src point has this particular vmap
{
val = vmap.getValue(src); // get the value of the src
vmap.setValue(tgt,val); // sets value of tgt point based on val
break;
}
vmap = vmap.next();
}


note that i havent tested the script above. but the process is somehting like it.

whattawa
03-10-2003, 03:42 PM
Thanks a lot. I'll give it a try.