View Full Version : Better: Cylinder creation tools

08-08-2015, 07:23 PM
Grrr. The "Disk" tool is a huge PITA to position via mouse when it is quite long in relation to its width.

The center cross hair is too close to the side sizers to target reliably.

What would be ideal is if the positioning gizmos were entirely clear of the sizing gizmos.

It would also be good if you could adjust one SIDE without the other side moving-- you can do this with the ends, but the sides always move in tandem. Aggravating. That might require a shift-combo to make it happen (although they all seemed to be in use currently).