PDA

View Full Version : FReq: Smarter Disk (Cylinder) tool



jeric_synergy
08-06-2015, 01:49 PM
1) Again, for the nth time, dialogs that usually take the same value (XYZ dialogs, often) should have a way to input only the first value, which is automatically copied to the other two. That's 1/3rd the typing. Just saying.

2) It'd be nice for the Disk Numeric Panel to be smarter about the axis: If I've designated the Y axis, it'd be good if it ghosted/protected the Y radius from over-writing, since I don't want that value to be changed.