PDA

View Full Version : TriCaster SD- Video Input showing up Black and White



shepherd
10-06-2014, 02:51 PM
Applies to: TriCaster Pro, Studio and Broadcast
Problem Description and Steps to Verify/Reproduce

This article describes how to troubleshoot black and white video input on a TriCaster SD unit. Meaning: Tricaster Pro, TriCaster Studio, and Tricaster Broadcast.

Steps to Fix / Workaround

Check to make sure you have your video input connected to the proper inputs on the front of the TriCaster.

Component cables should be connected as follows:
Y = Green,
Pb = Blue,
Pr = Red
Composite, unless otherwise marked “composite” use the Y input.
S-Video is labeled Y/C

If the video source is properly connected. Check the “Input Setup” tab under TriCaster “Live Production” tab.

Click-on “Input Setup” (see image below)
then click-on “Input” from the drop down menu, select the input you are experiencing the problem on. (see image below)
To the right in the section labeled “Type”, select the video signal accordingly. (Ex: SDI, Component, Composite, or Y/C (S-Video))
124788


If you’re still experiencing problems, power the TriCaster off and re-seat the VT Card following the instructions in the article “Re-Seat VT Card”. If problems presist, contact Customer Support (1-800-862-7837).