PDA

View Full Version : DUniSlide: limitation? Point sliding on open edge?



jeric_synergy
09-30-2014, 01:51 AM
I'm trying to use DUniSlide to space one point on the open side of cylinder (think "mouth of a cup"), but it appears that DUniSlide will only side the point on the NON-open side (the side of the cup)(it's not really a cup).

Is there a point slider that will operate on an open edge?

Waves of light
09-30-2014, 02:21 AM
Let me get this right, disk tool, create disk with height. Delete top poly makes an open edge. Select point, run DUniSlide - slide point?

Because that works for me.

jeric_synergy
09-30-2014, 09:23 AM
After a reboot, I can get the point to slide along 2 of the 3 edges it's connected to. More later.