View Full Version : Help with missing overlay options

08-01-2014, 02:49 PM
I have a NewTek Tricaster with an interface similar to this: http://www.dvsdirect.com/xd300.htm . I am able to follow the instructional DVD without any problem until it gets to the section shown in the picture I've attached.123390

That box with the Overlay controls doesn't seem to exist in my interface and I am wondering if there is some alternative to the tools pictured, or if they can be turned on and off, or if I perhaps have a different model than the one pictured, or what the issue could be?

08-01-2014, 05:29 PM
That picture is from the old (OLD!) version of software on the TC300. At some point (not sure when) the interface slightly to three horizontal rows of buttons. Does your interface look more like the picture I attached?

08-01-2014, 06:06 PM
I can't go look at the Tricaster right now (it's across town) but I'm inclined to say yes! Is there documentation for that interface somewhere on the web?

08-01-2014, 06:44 PM
The docs for any version of TriCaster are installed on the system (C:\TriCaster\Documentation), if that helps at all ...

08-04-2014, 12:23 AM
Thanks Steve, I will check it out.