View Full Version : Translate based on 2 points?

05-05-2014, 11:50 PM
Is there any quick easy way to move everything on a layer, based on the difference between 2 points?

I have been given several models which are more or less variations on each other, but they are not registered to each other. I would like to just say, "this point is the same in each model, make it so."

05-05-2014, 11:55 PM
The new translate tool should help.

I've used this to get an item to line back up with the origin. https://www.lightwave3d.com/assets/plugins/entry/de_rotate/

So you could use these together. Use one to line up your models to the origin. Then the other to snap your models to an alike point.